MZ527N
MZ527N
Alarm contact for motor starter 2C
| Cat ref.: | MZ527N |
| EAN No.: | 3250614565120 |
| P.U.: | 1 prt. |
close all
open all| Maximum poles of the main device: | 3 |
| Rated operational voltage Ue: | 220/500 V |
| Frequency: | 40/60 Hz |
| Type of supply voltage: | AC |
| Rated insulation voltage: | 690 V |
| Rated impulse withstand voltage: | 6000 V |
| Rated operational voltage in DC: | 24/220 V |
| Acceptable current rating with AC1: | 3 A |
| simulation fault current: | Non |
| Maximum current: | 25 A |
| Imin = f (U = 230 V AC): | 3 A |
| Imin = f (U = 230 V DC): | 0,25 A |
| Imin=f(U=24V DC) for power circuit: | 2 A |
| Imin=f(U=400V AC) for power circuit: | 2 A |
| Total power loss under IN: | 0,2 W |
| Power loss per pole at In: | 0,1 W |
| Electric endurance in number of cycles: | 5000 |
| Number of mechanical operations: | 10000 |
| Depth of installed product: | 68 mm |
| Width of installed product: | 9 mm |
| Tightening torque: | 1,3Nm |
| Factory fitted: | no |
| Connection cross-sect. flexible cable: | 2,5mm² |
| Connection cross-sect. rigid cable: | 2,5mm² |
| type of connection: | with screw |
| Type of contacts: | 2NO |
| Type of accessory: | fault-signal contact |
| Quantity of NO contacts: | 2 |
| Number of auxiliary contacts as fault signal: | 2 |
| European directive WEEE: | concerned |
| Protection index IP: | IP20 |
| Degree of pollution according to IEC 60664 / IEC 60947-2: | 3 |
| Altitude: | 2000 m |
| Storage temperature: | -25 to 80 °C |
| Air humidity protection: | 95% / 80°C |
- MZ527N
MZ527N
Data is subject to errors and technical modifications.
